MV69E-MBTCP是一种Modbus TCP/IP增强型通信模块。它必须与兼容电源一起安装，并且在CompactLogix机架中至少有—个空闲插槽。MVI69E-MBTCP的电源距离额定值为4。与CompactLogix1769-L43和1769-145一起使用时，将MVI69E-MBTCP安装在1769总线的前两个插槽上。MVI69E-MBTCP配有一个RJ45通信端口，支持10/100 Base-T以太网数据速率。它还要求使用ProSoft配置生成器和ProSoft发现服务。MV69E-MBTCP支持客户端和服务器连接。它可用于连接各种支持MODBUS的设备。它支持浮点数据移动，也支持Enron、Daniel和其他浮点数据实现。
MVI69E-MBTCP
它支持MODBUS功能，读取线圈状态;读取输入状态; 读取保持寄存器;读取输入寄存器;强制单线圈;预置单保持寄存器;诊断仅从机，响应子功能O0;强制多个线圈;预置多个保持寄存器;报告从ID;屏蔽写保持寄存器和读/写保持寄存器。该模块装运时设置跳线关闭。用作Modbus TCP/IP网络之间的输入和输出通信模块。MVI69E-MBTCP可与MODBUS兼容设备通信，也可作为总线网络和CompactLogix背板之间的通信模块。建议用于以太网连接的电缆为5类或更高级别。该模块需要安装在机架上，安装后，用户需要检查模块是否足够安全，以避免将模块集成到系统中时出现问题。
MVI69E-MBTCP
MV69E-MBTCP is a Modbus TCP/IP enhanced communication module. It must be installed with a compatible power supply and have at least one free slot in the CompactLogix rack. The power distance rating of MVI69E-MBTCP is 4. When used with CompactLogix1769-L43 and 1769-145, install MVI69E-MBTCP on the first two slots of the 1769 bus. MVI69E-MBTCP is equipped with an RJ45 communication port that supports 10/100 Base-T Ethernet data rates. It also requires the use of ProSoft configuration generators and ProSoft discovery services. MV69E-MBTCP supports client and server connections. It can be used to connect various devices that support MODBUS. It supports floating-point data mobility, as well as Enron, Daniel, and other floating-point data implementations.
MVI69E-MBTCP
It supports MODBUS function to read coil status; Read input status; Read the holding register; Read input registers; Forced single coil; Preset single hold register; Diagnosis only from the machine, response sub function O0; Force multiple coils; Preset multiple holding registers; Report from ID; Mask write hold registers and read/write hold registers. The module is shipped with the jumper closed. Used as an input and output communication module between Modbus TCP/IP networks. MVI69E-MBTCP can communicate with MODBUS compatible devices and can also serve as a communication module between the bus network and the CompactLogix backplane. The recommended cable for Ethernet connection is Class 5 or higher. The module needs to be installed on a rack, and after installation, the user needs to check whether the module is safe enough to avoid problems when integrating the module into the system.
There are no reviews yet.