5136-RE2-PCI是由信实电气为PCI计算机制造的接口卡。此接口卡具有PCI计算机在Reliance DCS-NET或远程I / O网络上充当插入的功能。该卡包括网络通信和远程I / O软件，并提供高速链路，避免了RS232串行连接的瓶颈。该接口卡的可能应用包括系统编程功能、统计过程控制 （SPC/SQC）、过程监控、操作员界面和 HMI、诊断以及系统启动和调试。
5136-RE2-PCI
5136-RE2-PCI
此单插槽 32 位 PCI 卡具有两个后置同轴 （BNC） 连接器。此卡的尺寸为 4.2 英寸（高）x 8.75 英寸（宽）。该卡需要 +5 545 mA（典型值）功率。储存温度必须保持在 -40 到 186° F 之间，工作温度必须保持在 32 到 127° F 之间。存储温度可能较低，因为设备在存储期间未运行，因此不会产生任何热量。一旦加载了远程I/O软件，该接口卡就可以监控远程I/O网络上的所有压降，访问从主站发送到从站的输出数据，并监控每个从站丢线发送到主站的数据。AutoMax编程执行软件（V3.3或更高版本）允许PCI计算机（安装有此接口卡）直接连接到Reliance DCS网络，并以全网络速度执行所有在线编程终端功能。
5136-RE2-PCI
5136-RE2-PCI
This single slot 32-bit PCI card has two rear coaxial (BNC) connectors. The size of this card is 4.2 inches (height) x 8.75 inches (width). This card requires+5 545 mA (typical) power. The storage temperature must be maintained between -40 and 186 ° F, and the working temperature must be maintained between 32 and 127 ° F. The storage temperature may be low because the device is not running during storage and therefore does not generate any heat. Once the remote I/O software is loaded, the interface card can monitor all voltage drops on the remote I/O network, access output data sent from the master station to the slave station, and monitor the data sent from each slave station to the master station due to cable loss. AutoMax programming execution software (V3.3 or higher) allows PCI computers (with this interface card installed) to directly connect to the Reliance DCS network and perform all online programming terminal functions at full network speed.
5136-RE2-PCI
There are no reviews yet.