东芝集团创立于1875年,致力于为人类和地球的明天而努力奋斗,力争成为能创造丰富的价值并能为全人类的生活、文化作贡献的企业集团,东芝集团
业务领域包括数码产品、电子元器件、社会基础设备、家电等东芝模块TOSHIBA 2N3A3110-C安装调试确保2N3A3110-C在设定地址前完成电力
排线.2N3A3110-C先送内机电源再送外机电源，如果在开启室内机之前开启室外机，外机P.C.板 上7段显示码会显示E19,直至开启室内机电源。
2N3A3110-C
.自动寻址可能会花费+分钟时间(正常为5分钟) .自动寻址要求在室外机操作。(仅打开电源不能自动寻址。 ) . 自动寻址会使用到室外机P.C.板界面
上的SW15按键1.首先送上室内机电源，然后再送室外机电源。2.电源送 上后确认室外主机P.C.板界面上7段显示板显示U.1.L08(此时U.1.闪烁)3.按下
SW15 (7段显示板有了变化松开，正常3秒左右)开始自动寻址(通常为5分钟)。4.7段显 示指示Auto1然后Auto2到Auto3指示U.1.- (U.1. 闪烁)开
始在显示器上闪烁后。闪烁停止显示器显示U.1.- -(U.1.灯常亮，设定完成。调试前准备工作1.确定保压正常,系统无漏。2. 算好铜管每米追加量与
机组的修正量。3. 液管与气管阀门打开。
2N3A3110-C
Automatic addressing may take+minutes (normally 5 minutes). Automatic addressing requires operation from an outdoor unit. (Only turning on the power cannot automatically address.) Automatic addressing will be used on the P.C. board interface of the outdoor unit
SW15 button 1. First, power on the indoor unit, and then power on the outdoor unit. 2. After the power is turned on, confirm that the 7-segment display board on the P.C. board interface of the outdoor host shows U.1.L08 (at this time, U.1. flashes) 3. Press
SW15 (the 7-segment display board has changed and is released, usually about 3 seconds) starts automatic addressing (usually 5 minutes). 4.7 segment displays Auto1, then Auto2 to Auto3 indicate U.1- (U.1 Flashing on
After flashing on the monitor. Flashing stops the display of U.1- (U.1. The light remains on and the setting is complete. Preparation before debugging: 1. Confirm that the pressure is maintained normally and the system is leak free. 2 Calculate the additional quantity per meter of copper pipes and
The correction amount of the unit. 3. Open the liquid and gas pipe valves.
2N3A3110-C
There are no reviews yet.